- [url=file:///C:\Users\thorstenlemke\AppData\Local\PG Offline 4\Attachments\cadintoshmac\Arc.PDF]Arc.PDF[/url]
For example;
- Draw two parallel lines spacing, 10mm
- Define two points at the end of lines
- Then "select point for side of center point" and input radius, 5mm
As shown on the attached PDF, dimension of the arc is changed according to the position I have pointed.
Green circles on the PDF show where I have pointed.
I cannot achieve correct dimension, 5.0, wherever I point.
However the radius of the created arcs are correct, R5 in this case.
This phenomenon was observed in version 7.xx too.
My system:
MacBook Pro retina, OSX Yosemite
Cadintosh 8.1 (build 200)