wolo bad boy horn at harbor freight

[David Giuliani]

I removed the stock front brake line and discovered there's not a clean way to transfer the protective rubber covers, grommets and spring over to the new stainless line. I can split the rubber mounting grommets, and maybe the other rubber stuff, but that spring doesn't look like it will pass over the end fittings. What do you guys do? Dave

[transalp 1]

The spring can be shelved. Not needed. For where the hose goes through guides, I've bought some fuel line with an inner diameter near that of the new brake line's outer diameter. Nothing fancy. A foot of auto parts store bulk line worked fine. Cut to size, split it, slip it over the barke line where needed and secure with small black plastic wire ties or contact cement. Done! =) eddie

> [Original Message] > From: David Giuliani > To: DSN_KLR650@yahoogroups.com> > Date: 8/11/2009 11:19:35 AM > Subject: [DSN_KLR650] brake line upgrade > > I removed the stock front brake line and discovered there's not a clean

way to transfer the protective rubber covers, grommets and spring over to the new stainless line. I can split the rubber mounting grommets, and maybe the other rubber stuff, but that spring doesn't look like it will pass over the end fittings. What do you guys do? Dave

> > >

[fasteddiecopeman]

Without installing a relay, I believe you won't get much improvement, if any. Probably the OEM horn WITH a relay, would be adequate. Cheers, Ed

--- In DSN_KLR650@yahoogroups.com, "Bass Jay" wrote: > > Has anyone tried the new KLR horn that Whitehorse Gear sells? It > supposed to be able to be installed without making any modifications > > >

[fasteddiecopeman]

Dave, I cut a piece of water hose (2" long?), then cut it down the side lengthwise so it'd fit over the brake-line, and used a nylon tie to attach it to the stock location (hoop). Cheers, Ed

--- In DSN_KLR650@yahoogroups.com, "David Giuliani" wrote: > > I removed the stock front brake line and discovered there's not a clean way to transfer the protective rubber covers, grommets and spring over to the new stainless line. I can split the rubber mounting grommets, and maybe the other rubber stuff, but that spring doesn't look like it will pass over the end fittings. What do you guys do? Dave >