Page 1 of 1
balance of ideas
Posted: Thu May 04, 2000 11:48 am
by Ray McCrary
Hi,
On the roll edge rim wheels (TA-TB) I have had motorcycle weights suggested
to balance. Has anyone done this..?
Best,
Ray McCrary
"Speed is Life;
of course Luck and Altitude
are helpful, too."
Re: [mg-tabc] balance of ideas
Posted: Thu May 04, 2000 11:59 am
by mrbadger
In my experience, stick-ons or wrapping solder around the spokes are the
two choices.
Derek
Ray McCrary wrote:
>
> Hi,
> On the roll edge rim wheels (TA-TB) I have had motorcycle weights suggested
> to balance. Has anyone done this..?
> Best,
> Ray McCrary
> "Speed is Life;
> of course Luck and Altitude
> are helpful, too."
Re: [mg-tabc] balance of ideas
Posted: Sat May 06, 2000 6:52 am
by Frank O_ The Mountain
In a message dated 5/4/00 11:52:11 AM Pacific Daylight Time,
spook01@home.com
writes:
>
I use lead wire wrapped around the spokes Ray, but I have seen motorcycle
weights used and the stickon leads too...
Terry