Re: [mg-tabc] crankshaft rear seals
Posted: Wed Apr 05, 2000 4:58 pm
Reference Viv James' question:
"Now, having read all the expert texts, I wonder if a Viton seal is not the
answer.
Can you or anyone else tell me the part number, size and how to make sure it
is the right material etc so that I can do some shopping before stripping
the engine again. "
I'd also like to know the answer to that. I bought and installed the Moss
seal - which right now with less than 200 miles on the engine is working
fine. But, if it's going to go bad and a new seal made with the right
material is available, I'd rather replace just the seal and not lose the
money I've invested in this setup by going to another.
Thanks in advance.
Gene
"Now, having read all the expert texts, I wonder if a Viton seal is not the
answer.
Can you or anyone else tell me the part number, size and how to make sure it
is the right material etc so that I can do some shopping before stripping
the engine again. "
I'd also like to know the answer to that. I bought and installed the Moss
seal - which right now with less than 200 miles on the engine is working
fine. But, if it's going to go bad and a new seal made with the right
material is available, I'd rather replace just the seal and not lose the
money I've invested in this setup by going to another.
Thanks in advance.
Gene