TA Wiring loom
Posted: Thu Mar 02, 2000 12:16 pm
From: To: Sent: Thursday, March 02, 2000 Subject: [mg-tabc] TA Wiring loom Hi all - Need help please! I am still restoring a TA that my father and I started in 1959! Is this a record? After my father died I threw the car together with enthusiasm and coat hangers and drove for two years around the south of England. I left university and returned to Northern Ireland where the rebuild restarted in earnest. That was 26 years ago but I am almost there. Now the crunch where does the wiring loom go? It comes down from the control box and into the chassis where the fuel lines come out; the tail and stop light wires go back and cross to the drivers side behind the hand brake cross bar. The main loom goes forward in the chassis box section the dynamo wires come out of one of the holes and the rest of the loom continues forward. The near sidelight and headlight comes out and goes inside the wing support tube, the fog light goes on forward and the rest of the loom is clipped either above or below the radiator support cross bar. Can anyone please help with the exact routing forward from where the dynamo wires come out? Regards Mike