Piston s wanted
Posted: Wed Sep 14, 2005 6:31 pm
I am in need of a set of 4 pistons and rings to suit, as follows:
Piston diameter 2.833 in. or 71.94 mm Oversize up to .060 in. also OK
Compression height (distance from center of wrist-pin/gudgeon-pin to piston crown) =1.69 in.
Wrist-pin/ Gudgeon-pin bore = 0.71 in.
Also need head gasket for MG VA with 72 mm cylinder bore (as in type TPDG engines offered for police use.)
Any leads/suggestions will be much appreciated.
Regards,
Carl Fritz
TC 6756 , VA 2009
Gainesville, Florida
email: carlmgtc@hotmail.com
[Non-text portions of this message have been removed]
Piston diameter 2.833 in. or 71.94 mm Oversize up to .060 in. also OK
Compression height (distance from center of wrist-pin/gudgeon-pin to piston crown) =1.69 in.
Wrist-pin/ Gudgeon-pin bore = 0.71 in.
Also need head gasket for MG VA with 72 mm cylinder bore (as in type TPDG engines offered for police use.)
Any leads/suggestions will be much appreciated.
Regards,
Carl Fritz
TC 6756 , VA 2009
Gainesville, Florida
email: carlmgtc@hotmail.com
[Non-text portions of this message have been removed]