Distributor Part

[Mark Stolzenburg]

While checking the distributor on the TC, I noticed one of the two screws holding the top plate (the plate that holds the points and condenser) seemed to be stripped. Upon further inspection I found it wasn't stripped at all but was too small. The diameter measured 1/8 inch. The other screw was bigger and measured 137 thousands in diameter and fit fine. Does anyone on the list have a spare screw (no wisecracks)? Its a cap-head screw measuring 137 thousand diameter and about 1/4 to 3/8 long. Thanks, Mark Stolzenburg St. Louis, Missouri, USA TC 7812 [Non-text portions of this message have been removed]