Roger Furneaux's "NUTS"!
Posted: Wed Dec 12, 2001 1:24 am
on 12/12/01 12:22 am, Gene Gillam at anngene@bellsouth.net wrote:
haven't> >> Just forget them and fit a pair of my new hexagonal hub-nuts with > double-lip > seals in them.< Roger Furneaux > > > Roger, > > I was among a group that recently bought the hub-nuts from you but I
the> had a chance to install them yet - one of those "things-to-do" jobs that > will eventually get done. I didn't realize that using them would negate
I used Roger Furneaux's HUB NUTS and they work just fine!! However I made one mistake!! Roger will supply a ring to fit on the shaft for the oil seal to run on. Perfectly machined to fit the lip seal. You do have to glue this ring in place on the shaft with an epoxy adhesive. When you do be very careful to make sure that you use sufficient adhesive to seal the ring to the shaft, the slot's in the shaft give problems. I carelessly didn't fully seal them. Consequently I still had very slight but very noticeable seepage of oil between the ring and the shaft. Problem was how to seal this leak. I couldn't withdraw the ring,after all it was glued in place! I solved this by scouring the RS catalogue and found a 'runny' silicon sealer which sets very slowly and ran down the gaps. It worked fortunately. Merry Xmas and a Happy New Year to all. Roger Muir Bromsgrove England> need for the slinger - or will the slinger still be needed as a spacer to > keep the half-shaft from flexing?