Page 1 of 1
exhaust sheild?
Posted: Wed Mar 06, 2013 4:37 pm
by mark ward
A Preemptive Question.
While TRYING to take out the screws, one screw looks stripped, So not sure how the "nut" is.
The other screw finaly snapped off. (after 20+ minutes of working it. Hot cold etc.)
While some have said , just cut off the old nuts and weld new, I worry about alignment of 2 nuts being just right.
Has anyone tryed, drilling out the holes, the weld NEW NUTS ON TOP OF THE OLD?
I'm thinking, While it WILL, bring the shield out about 1/4 inch, I would have them in alignment using the old stumps as guides.
START THE THREAD NOW... LOL
Thanks ahead.
[Non-text portions of this message have been removed]
myler's radiator reinforcement
Posted: Thu Mar 07, 2013 8:13 am
by Jeff Saline
On Thu, 07 Mar 2013 00:01:47 -0600 Nathan Nichols
writes:
> Anyone with a 2008+ had a radiator reinforcement done by Myler's? If
> so,
> were you happy with it?
>
> Nate
<><><><><><>
<><><><><><>
Nate,
I've read multiple reports of very good service and repairs. No personal
experience with Mylers.
Best,
Jeff Saline
ABC # 4412 South Dakota Airmarshal
Airheads Beemer Club
www.airheads.org
The Beautiful Black Hills of South Dakota
75 R90/6, 03 KLR650
.
.
____________________________________________________________
Woman is 53 But Looks 25
Mom reveals 1 simple wrinkle trick that has angered doctors...
http://thirdpartyoffers.juno.com/TGL3141/5138a0673a90b206607ffst04vuc