Wilsons Sandbox

Posted: **Wed Aug 29, 2012 7:36 am**

Fred (or anyone else who may know), Are the main harnesses the same for all the 87-07 KLR's including Tengai? I know of someone who has a ubrnt up harness in his Tengai. -David [Non-text portions of this message have been removed]

Posted: **Wed Aug 29, 2012 9:55 am**

You should probably set it as high as you can get it for two-up. The stock shock is a little weak. You only turn it clockwise. If you go past the highest setting, it drops back down. You'll know it when you feel it. If I was you I'd just set it on the highest setting but check it every once in a while. Mine would actually reset itself. I have no idea why. I bought a Progressive shock. Expensive, but nice. Robert Wichert P.Eng. LEED AP BD&C +1 916 966 9060 FAX +1 916 966 9068 ===============================================

On 8/29/2012 6:53 AM, bryanonfire wrote: > > Hi, > > I would look this up in the old posts if I could, but I have very > limited internet access. > > Just bought an early E model in the Czech Republic and it looks to be > in good shape. I will be riding with rider plus gear weighing in at > about 250 - 260 pounds but sometimes may have a passenger on the back > bringing the weight up to 400. It will be almost entirely road miles, > just an occasional pothole or speed bump to worry about. > > What rear shock pre-load setting do I want, and how do I set it? I > know where the fitting is but remember reading something about only > turning one way. The Clymer manual says very little. It is on 1.5 > right now. > > Same question about the rebound dampening. > > Thanks > > Bryan > > [Non-text portions of this message have been removed]

Wilsons Sandbox

rear shock setting

wiring harnesses compatibility for 87-07 klr's including tengai.

rear shock setting