Page 1 of 1
vance & hines xcr exhaust update
Posted: Fri Aug 03, 2012 10:51 am
by dat brooklyn bum
Prior to putting this exhaust on, I had installed a KLX needle on the 2nd position, adjusted the idle mix screw, and drilled the slide. My mileage was usually around 44 mpg with these mods and the stock, detweeted exhaust.
Installation of the XCR improved throttle response across the powerband, though I doubt I gained any significant hp. The torque on the bottom seems much improved and roll-on power from 3K to 6K rpm is definitely up. My mpg went up 47 on my first tank, and I wasn't taking it easy with the throttle. This is all with the quiet insert. I will never find out what the race insert does for the package because it would be way too loud for me. Loud pipes lose rights. Once I get the spark arrester insert I'll let you know how that goes.
Is it worth the investment? It is if you can get one for $76 with a bag of packing like I did.
da Vermonster
bridgestone uhd tube update
Posted: Fri Aug 03, 2012 3:37 pm
by Tengai Mark Van Horn
I'm mounting new tires on the Tengai today and just pulled off the old ones.
The Bridgestone UHD innertubes that were in the wheels were mounted
in May of 2005 and have gone through 2 sets of Conti Escapes (16,000
miles total.
The tubes are in pristine condition and I would be confident to use
them again. However, I bought a new set of tubes just in case, and
will mount them since I already have everything apart.
I'll mount the old ones on a backup set of wheels I keep in the garage.
Mark
bridgestone uhd tube update
Posted: Fri Aug 03, 2012 3:44 pm
by Fred Hink
When you take off your BS UHD tubes, see if they don t sound like there are BBs inside your tube. For what ever reason, these tubes seem to pick up rubber and make little balls that roll around and make noise but don t seem to effect anything else with these tubes.
Fred
http://www.arrowheadmotorsports.com
From: Tengai Mark Van Horn
Sent: Friday, August 03, 2012 2:31 PM
To:
DSN_KLR650@yahoogroups.com
Subject: [DSN_KLR650] Bridgestone UHD Tube Update
I'm mounting new tires on the Tengai today and just pulled off the old ones.
The Bridgestone UHD innertubes that were in the wheels were mounted
in May of 2005 and have gone through 2 sets of Conti Escapes (16,000
miles total.
The tubes are in pristine condition and I would be confident to use
them again. However, I bought a new set of tubes just in case, and
will mount them since I already have everything apart.
I'll mount the old ones on a backup set of wheels I keep in the garage.
Mark
[Non-text portions of this message have been removed]