Page 1 of 1
wtb - head to fit a 2003 klr
Posted: Sat Jul 14, 2012 1:42 pm
by Guy Young
Working on a customer's bike. Waited too long to adjust the valves and one exhaust clearance go too tight, which resulted in a burned exhaust valve. Destroyed the valve and the valve's seat area of the head.
Whatchagot??
Either PM, or email me at: gbyoung2 at versizon dot net
PS: This is the same bike I asked a question about earlier. Finally got off my duff and did a leak down test. This showed the exhaust valve(s) were leaking. Pulled the head and found the problem.
Last pages at:
http://gbyoung2.smugmug.com/Motorcycles/Busansky-KLR-1/22968668_MM3dJm
wtb - head to fit a 2003 klr
Posted: Sat Jul 14, 2012 4:41 pm
by Warren Brandt
Nice pictures.
How many miles on the engine?
--- In
DSN_KLR650@yahoogroups.com, "Guy Young" wrote:
>
> Working on a customer's bike. Waited too long to adjust the valves and one exhaust clearance go too tight, which resulted in a burned exhaust valve. Destroyed the valve and the valve's seat area of the head.
>
> Whatchagot??
>
> Either PM, or email me at: gbyoung2 at versizon dot net
>
> PS: This is the same bike I asked a question about earlier. Finally got off my duff and did a leak down test. This showed the exhaust valve(s) were leaking. Pulled the head and found the problem.
>
> Last pages at:
>
>
http://gbyoung2.smugmug.com/Motorcycles/Busansky-KLR-1/22968668_MM3dJm
>
fs: 2006 klr excellent condition
Posted: Sat Jul 14, 2012 8:47 pm
by larslemberg
I've decided to sell my 2006 KLR, Northern Virginia Washington DC area.
http://washingtondc.craigslist.org/nva/mcy/3136443490.html