Wilsons Sandbox

Posted: **Tue May 29, 2012 5:05 pm**

Hey does anyone know for sure, will a rear caliper of an 2011 fit an 07? [Non-text portions of this message have been removed]

Posted: **Tue May 29, 2012 5:49 pm**

No, the brakes are completely different starting in '08. -Jeff Khoury

----- Original Message ----- From: "mark ward" To: "List KLR" DSN_KLR650@yahoogroups.com> Sent: Tuesday, May 29, 2012 3:05:21 PM Subject: [DSN_KLR650] 07&11 Rear caliper fit? Hey does anyone know for sure, will a rear caliper of an 2011 fit an 07? [Non-text portions of this message have been removed]

Posted: **Wed May 30, 2012 9:42 am**

I am thinking "Wire Tie". Maybe a few of them. Why did it get caught by the fender anyway? What kind of negligent abuse did I give it? Was the mud too much? Was the pressure washer too much? Was the dirt (actually mud) nap too much? Robert Wichert P.Eng. LEED AP BD&C +1 916 966 9060 FAX +1 916 966 9068 ===============================================

On 5/30/2012 7:29 AM, Tengai Mark Van Horn wrote: > I had that "tip" rust off of one of my bikes. I welded a small screw > to the screen. > If you don't have access to free welding, you can certainly MacGuyver > something. > > Mark > > > At 6:42 AM -0700 5/30/12, RobertWichert wrote: > > The inboard attachment point is kind of odd though. It is some sort of > "tip" that fits into a slot. I'm not sure that I can duplicate that, > but I'm going to try the "fix it" route. [Non-text portions of this message have been removed]

Wilsons Sandbox

radiator screen

07&11 rear caliper fit?

07&11 rear caliper fit?

radiator screen