Page 1 of 1
sheet iron
Posted: Wed Mar 28, 2012 11:41 am
by RobertWichert
Is anybody planning to do the Sheet Iron this year? Applications can be
submitted no earlier than April 1.
--
Robert Wichert P.Eng. LEED AP
+1 916 966 9060
FAX +1 916 966 9068
===============================================
nklr vespa cdi and motor upgrade advice pls from any electrical type
Posted: Wed Mar 28, 2012 12:08 pm
by Jeffrey
OK CDI experts, I have a 1962 Vespa VNB3T that I put a 2002 LML Vespa/Bajaj/Stella Engine in.
Went from 1 port, 6V, points to 5 port 12V CDI
4hp to 10 hp
I rigged a solid copper spark plug wire and ran a no resistance spark plug wire connector to the no resistance B6ES plug
The grey coil it came with started messing up; auto-retard? or just didn't like no resistance. So, I got a post 2006 Red CDI and it worked fine. I went to get some new spark plugs and could only find RN9YC which have resistance.
Should I run a resistor plug or not? Also, I am having a hard time figuring out the kill switch.
Thanks in advance,
Jeffrey
http://www.scooterworks.com/wiki/lml_engine_install_faq.ashx