Page 1 of 1

seat sculpting?

Posted: Sat Jun 04, 2011 10:20 am
by David H. Klaus
Success! A friend who does auto interiors helped me sculpt the Kawa gel seat front end so I can sit comfortably far forward (nearly on top of the gas tank). The gel is buried under !" or more of medium density foam. The foam was easy to trim using an electric knife (just like in the old days). This project was much easier than I'd expected and feared. Thanks for the suggestions. Dave

fred's ato fuse relocation kit and always on headlight issue

Posted: Sat Jun 04, 2011 11:17 am
by kevincrossett
I just installed Fred's ATO fuse kit and now the headlight comes on with the bike ignition in the off position. Any ideas why the headlight would turn on without the key switched to the on position after the installation? Help???

fred's ato fuse relocation kit and always on headlight issue

Posted: Sat Jun 04, 2011 11:36 am
by Mike Huber
Sounds like you have your wires crossed....Make sure one fuse (batt) has the 2 white wires going to it and the other fuse (ign) has the blue/white and red wires going to it. Mike Huber Carlsbad NM To: DSN_KLR650@yahoogroups.com From: kcrossett@... Date: Sat, 4 Jun 2011 16:17:32 +0000 Subject: [DSN_KLR650] Fred's ATO fuse relocation kit and always on headlight issue I just installed Fred's ATO fuse kit and now the headlight comes on with the bike ignition in the off position. Any ideas why the headlight would turn on without the key switched to the on position after the installation? Help??? [Non-text portions of this message have been removed]