Page 1 of 1
shims/when? & where?
Posted: Sat Apr 23, 2011 8:17 am
by mark ward
Where? (get it out the way.) Robin Where Are you?
Jeff S. & Fred Last fall (@ 10,000miles) I checked and 2 shims were great (in the middle specs.) 2 were Close. I put about 3500 on since. How often should I tear it down to check them?
Starts fine power (seams) is fine all gears.
Mark (W. Michigan)
[Non-text portions of this message have been removed]
non klr/ no garrage space/porch, $15. +-
Posted: Sat Apr 23, 2011 8:29 am
by mark ward
Hey Just a tip, My Garrage is FULLLLLLL with bikes in, no where to work. Table saw welders, Bikes, ETC. ETC.
A few years ago I put lag hooks on the front of the garrage, and made an (tent like )AWNING
(hooks with Lagbolt ends, Home depot or hardware .68cents each.),
Blue tarp, 2, 2x4's with a nail or screw in one end, roap and 2 tent stakes or something to tie them down to.
15 minutes Up, 5 to take down,(before the Nieghbors start yelling and city BITCHS.)
Works GREAT on rainy or HOT sunny days, Leave an end down blocks the wind for Mig welding too.
Mark (West Michigan)
[Non-text portions of this message have been removed]