Page 1 of 1
'00 restoration
Posted: Mon Mar 07, 2011 6:22 pm
by Andrus
Well, underside of gas tanks painted a slightly darker green after sanding and wire brushing as much of the rust as I could reach. just surface stuff. Cleaned , sanded and washed fenders and Cowling. Need to do a few more green faded parts tomorrow.
Amazed I still had fork seals for it in stock. The front end will be the next project after painting is done.
Needs to be about 20 degrees warmer in the early morning and I would start earlier. But then, tomorrow is Marti Gras. Everyone from the South knows what that's about.
Me and Da Bandit gonna roll.
drilling out mount holes on a rotor
Posted: Fri Mar 25, 2011 6:58 pm
by dat brooklyn bum
Made by Motomaster.
I'll probably start looking for a friend with a drill press.
da Vermonster
--- In
DSN_KLR650@yahoogroups.com, RobertWichert wrote:
>
> I'd probably ask the manufacturer. Who made it?
>
>
> Robert P. Wichert P.Eng LEED AP
> +1 916 966 9060
> FAX +1 916 966 9068
>
>
>
>
>
>
>
>
>
>
>
> ===============================================
>
>
> On 3/25/2011 10:24 AM, dat brooklyn bum wrote:
> >
> > I bought a supermoto rotor off of ebay in the fall and just today got
> > around to attempt mounting it only to discover that the mount holes
> > are too small for the mounting bolts. They are lined up, just not big
> > enough. Would you drill them out if you were in my situation?
> >
> > da Vermonster
> >
> >
>
>
> [Non-text portions of this message have been removed]
>