carb question from a past poster
Posted: Wed Mar 23, 2011 6:22 pm
For some reason, my first try sending this via the web interface, my
message never made it to the list.
Anyway, I'm assuming he broke the cable and that the plunger & spring
in the carb are intact.
If so, cut the insulation from the cable. Then, cut the cable,
leaving about a foot of it going into the carb. Tie a finger loop in
the end of the cable. Manually pull and hold choke and start the
bike. Keep it held until the bike warms up a bit.
Mark
At 11:04 AM +0000 3/23/11, albatrossklr wrote:
O great gurus of all things KLR fuel systems, friend Jacob of
highlands has broken his choke and needs advice & perhaps a bit of
magic to help him start the KLR without a choke until he can receive
parts from the hinterlands.
I'll pass along all your good advice.
[Non-text portions of this message have been removed]