seat question

DSN_KLR650
Post Reply
Fred Hink
Posts: 2434
Joined: Thu Apr 06, 2000 10:08 am

seat question

Post by Fred Hink » Mon Oct 18, 2010 10:41 am

That'd work or you could drill out the rivets. Fred http://www.arrowheadmotorsports.com     [b]From:[/b] transalp1@... [b]Sent:[/b] Monday, October 18, 2010 9:13 AM [b]To:[/b] DSN_KLR650@yahoogroups.com [b]Subject:[/b] Re: [DSN_KLR650] Seat Question     If the slotted front mounting point is the drawback, I could see a Dremel removing it and a small block of rubber glued in it's place, yes? =) eddie    
----- Original Message ----- [b]From:[/b] moabmc@... [b]To: [/b]DSN_klr650@yahoogroups.com [b]Sent:[/b] 10/18/2010 11:11:05 AM [b]Subject:[/b] Re: [DSN_KLR650] Seat Question [b]From:[/b] moabmc@... [b]Sent:[/b] Monday, October 18, 2010 9:09 AM [b]To:[/b] phreedeom@... [b]Subject:[/b] Re: [DSN_KLR650] Seat Question The difference is that the 08 and later KLR has an extra mounting point on the front side of the seat and the 07 and earlier doesn't.  You could put an early model on a late model KLR and it will fit, the only "issue" may be that the seat is loose in the front.  Putting a late model seat on an early model KLR could scratch the tank where this front mounting point is on the seat. Fred http://www.arrowheadmotorsports.com


Post Reply

Who is online

Users browsing this forum: No registered users and 19 guests