any comments on xena alarm lock?

DSN_KLR650
Post Reply
Brad
Posts: 101
Joined: Mon Jun 09, 2003 8:14 am

engine?

Post by Brad » Fri Sep 03, 2010 3:32 pm

Just below the valve cover, cam chain side, there's 2 round looking plugs with a hex fitting. What are these. Can't find anything in my manual. The front one is sweating a little oil. Busy doing carb mod, Thermo Bob, doohicky and Happy Trails panniers, crash bar and skid plate. So far all is going well. Brad 09 KLR

wingerr
Posts: 19
Joined: Mon Aug 01, 2005 3:38 pm

any comments on xena alarm lock?

Post by wingerr » Fri Sep 03, 2010 3:56 pm

Is the sensitivity of the alarm adjustable to prevent false tripping? Does it tend to go off at all when you're removing it? Weather resistant?
--- In DSN_KLR650@yahoogroups.com, Dave Klaus wrote: > > Got it. Love it. > > Any specifics you're looking for? > > Dave >

k650@verizon.net
Posts: 82
Joined: Mon Jun 07, 2010 3:50 pm

engine?

Post by k650@verizon.net » Fri Sep 03, 2010 4:26 pm

They are just plugs - probably a tapered pipe thread. The other side is the area where the cam chain resides. They don't do anything else except plug the hole. On their centerlines in the head on the other side of that area are threaded holes. It is just a guess but they may be there so you can remove the plug and thread a bolt in there to keep the chain from falling down when you remove the cams? Anyway make sure they are actually leaking and that the oil is not coming down from the valve cover gasket. If you are sure they are leaking try tightening them a tweak. If that doesn't work you can safely remove them and then I would recommend using Teflon tape. Walt -----Original Message----- From: DSN_KLR650@yahoogroups.com [mailto:DSN_KLR650@yahoogroups.com] On Behalf Of Brad Sent: Friday, September 03, 2010 16:32 To: DSN_KLR650@yahoogroups.com Subject: [DSN_KLR650] Engine? Just below the valve cover, cam chain side, there's 2 round looking plugs with a hex fitting. What are these. Can't find anything in my manual. The front one is sweating a little oil. Busy doing carb mod, Thermo Bob, doohicky and Happy Trails panniers, crash bar and skid plate. So far all is going well. Brad 09 KLR

Post Reply

Who is online

Users browsing this forum: No registered users and 30 guests