Page 1 of 1
help. chain and sprocket kit recommendation needed
Posted: Thu Aug 13, 2009 6:00 pm
by Richard Decker
I have a JT front and rear on mine with an RK oring chain. Seems to hold up
pretty good, but only have 3K on the set. I replaced the stock stuff at
9,500 because the chain was starting to bind up due to rust... that,
ofcourse is before I learned to take care of stuff...
On Wed, Aug 12, 2009 at 3:23 PM, Spike55 wrote:
>
>
> I currently have 17,500+ miles on a stock 15T, a JT 44T rear, stock chain,
> I have plenty of 'tooth' left, and I'm only at the 3rd mark back. Over the
> years, I've used some WD40, some BelRay, some Chain Wax, some JP-1 and
> everything seems to be good to go for at least another 10,000 miles or more.
>
> Many have criticized my loose chain, at rest, but when my fat a** and
> equipment gets on the bike, that chain gets just right.
>
> When I have to, I'm going with the same set-up. Works for me.
>
> Don TR100, A6F
>
> --- In
DSN_KLR650@yahoogroups.com , Robert
> Waters wrote:
> >
> > Greetings,
> > Thanks for all the help. One fellow recommended Eagle Mike, but I could
> not get his web site to come up. I wound up ordering off Ebay. Here is the
> ULR:
> >
> > Kawasaki KLR 650 90-09 15/43 Chain/Sprocket Combo
> > Item# 390070549854
> >
> > Did I do ok?
> > rw
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>
>
--
-
Rich Decker
Democracy is two wolves and a lamb voting on what to have for lunch. Liberty
is a well-armed lamb contesting the vote.
[Non-text portions of this message have been removed]
"dyna beads", and other thoughts....
Posted: Thu Aug 13, 2009 6:05 pm
by Richard Decker
Come to think about it... my Bronco didnt start smoking until a few kmiles
after I put in the K&N panel. Dag snabit, rebuilding an EFI 351 isnt
cheap... and to think I did it for 5 hp? That's going to be like $250 per
horse...
On Wed, Aug 5, 2009 at 5:23 AM, Dooden wrote:
>
>
> K&N Krappy & Nogood
>
> I see alot of vehicles daily and seems like a very high percentage of
> vehicles that have the motor tore down when I see them always have a K&N
> filter laying in the back seat with the rest of the engine parts.
>
> My Thoughts.
>
> Dooden
> A15 Green Ape
>
>
> --- In
DSN_KLR650@yahoogroups.com , "Ross
> Lindberg" wrote:
> >
> >
> >
> > Just a thought about your K&N. I have a Dodge 3500 dually with the
> Cummins
> > in it that had a K&N filter in it. It had been an on-highway truck when
> we
> > purchased it. I ran that truck almost 2 years without the K&N getting
> > dirty. I found this puzzling because the dirt we deal with while in
> > California is like talcum powder when it gets dry. We started getting
> some
> > blue smoke coming from the exhaust, a sign of burning oil. I switched to
> a
> > stock paper filter and found myself changing air filters twice a year.
> That
> > little experiment tells me that the K&N wasn't catching much dirt even
> > though it was properly oiled.
> >
> >
> >
> > So your buddy cleaned his filter every dusty day, while you made it the
> > entire trip without cleaning. It is reasonable to assume that since you
> > both rode together and took the same route, your engines inhaled the same
> > amount of dust. His dust wound up in his air filter. Where did your dirt
> > go? Inside your engine. Not a good place for it to be.
> >
> >
> >
> > K&N brags in its advertising that owners of racing engines trust their
> > investment to K&N filters. Sounds great, right? Consider for a moment the
> > expected lifespan of a racing engine. It's not anywhere near that of the
> > engine in your daily driver, or your motorcycle for that matter. Racing
> > engines are built for maximum performance, not maximum lifespan.
> Personally,
> > the only vehicle I would put a K&N filter on is something I would drive
> to a
> > demolition derby.
> >
> >
> >
> > Did the K&N add performance to my Cummins? Yes slightly, but at the cost
> of
> > drastically decreased engine life. Ask a diesel mechanic what the cost is
> > of an engine rebuild and you will be shocked. It ain't cheap and
> certainly
> > not worth the added performance and modest fuel mileage increase.
> >
> >
> >
> > I'm running a Twin-Air filter from our man Fred. My seat-of-the-pants
> > feeling is that there is a bit of an increase in airflow, and an added
> bit
> > of power. The inspections I have made when washing the filters tells me
> > that there is a more even flow of air at all points of the filter; much
> > better than the stock filter. An added plus is that the interior of the
> > filter has remained oily and clean, while the outside gets pretty nasty
> at
> > times.
> >
> > Using No Toil oil and cleaner, clean-up is a snap and takes just a few
> > minutes.
> >
> >
> >
> > I don't mean to rain on your parade, just giving you the benefit of my
> > experiences.
> >
> >
> >
> > Ross Lindberg
> >
> > Fertile, MN
> >
> >
> >
> > _____
> >
> > From:
DSN_KLR650@yahoogroups.com [mailto:
>
DSN_KLR650@yahoogroups.com ] On
> > Behalf Of fasteddiecopeman
> > Sent: Tuesday, August 04, 2009 3:48 PM
> > To:
DSN_KLR650@yahoogroups.com
> > Subject: [DSN_KLR650] "Dyna Beads", and other thoughts....
> >
> >
> >
> >
> >
> >
> > K&N Air Filter - My buddy washed his stock air filter after every dusty
> day
> > while I waited till home and did my K&N just once. Two thumbs UP!
> >
> > Just some thoughts....
> >
> > Cheers,
> > Ed
> >
> >
> >
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>
>
--
-
Rich Decker
Democracy is two wolves and a lamb voting on what to have for lunch. Liberty
is a well-armed lamb contesting the vote.
[Non-text portions of this message have been removed]