Page 1 of 1
ims footpeg installation
Posted: Sat Feb 21, 2009 1:24 pm
by sourdoughmedic
Brethren- I am attempting to replace my stock pegs with IMS pegs.
Problem: where/how to put/place the spring. Talking about the about
the "U" shaped end to the footpeg bracket, there are no holes except
the mounting pin holes.
Can anyone help me out?
No they did not come with instructions.
Thank you
Larry
postings
Posted: Sat Feb 21, 2009 6:43 pm
by Doug Herr
On Sun, 2009-02-22 at 00:31 +0000, hill_buster wrote:
> I find it strange that when replying to postings only half of my replies get posted.
>
> I did a test last week & got instant results. Today I was replying to Legrains message
> & the discussion list did not record my response..
>
> Hmmm, am I being censored.............paranoia slowly setting in.
A "fresh" post will go to the group by default.
A reply will just go to the poster by default.
I am about to change the "To:" line to the group address so that you are
not the only person to see my reply.
--
Doug Herr
doug@...
A16 in Oakland, California