alaska trip
Posted: Mon Jun 23, 2008 10:36 pm
On Jun 23, 2008, at 8:47 AM, E.L. Green wrote:
Easy enough to drill holes in the side panels to provide access to the seat screws without taking the side panels off. Also, several folks have run quite successfully without bolting the seat down; just make sure the front of the seat is correctly secured and (optionally) use a little Velcro on the back end. -- Blake Sobiloff http://www.sobiloff.com/> San Jose, CA (USA) [Non-text portions of this message have been removed]> Not true. The left side panel serves to prevent rain and road mist > from being sucked into the air inlet, the right side panel serves to > protect the seat (and the rider!) from heat rising off of the pipe,