Page 1 of 1
klr wood stand or lift?
Posted: Thu Jan 26, 2006 10:09 pm
by Michael F. Hagen
Looking for the link that was passed around last year showing the building
of a KLR wood lift, I think it used 2X4 and 2X3s. I searched under "stand"
, "wood" ect. I could not find the website. I know there were pictures and
exact dimensions on making one?
A friend just bought a 2005, didn't want to pop for the Pep Boys MC jack I
got?
Thanks
Mike Hagen
eBay Red - A18
klr wood stand or lift?
Posted: Thu Jan 26, 2006 10:54 pm
by Bryan
Here you go, I built one but it collapsed on me, I ended up just
buying a center stand.
http://www.klr650.marknet.us/lift.html
Later, Bryan Dolan
Houston, TX
--- In
DSN_KLR650@yahoogroups.com, "Michael F. Hagen"
wrote:
>
> Looking for the link that was passed around last year showing the
building
> of a KLR wood lift, I think it used 2X4 and 2X3s. I searched
under "stand"
> , "wood" ect. I could not find the website. I know there were
pictures and
> exact dimensions on making one?
>
> A friend just bought a 2005, didn't want to pop for the Pep Boys
MC jack I
> got?
>
> Thanks
>
>
> Mike Hagen
> eBay Red - A18
>
hot topic
Posted: Fri Jan 27, 2006 10:42 am
by Matt
--- In
DSN_KLR650@yahoogroups.com, Eric Lee Green wrote:
>
>I'd show you my setup, but my setup is a bit more complicated because
I > also use the same relay-driven wire to drive ...snip
My connection wasn't complicated at all. I simply tapped into the hot
(white) wire of my ignition switch. Don't cut the wire. Just remove a
section of insulation, untwist the wire, push the new wire through,
twist, solder, and insulate.
Matt