Wilsons Sandbox

Posted: **Thu Aug 08, 2002 9:05 am**

I had a KLR in my shop a while back that had the tall Kawasaki windshield. The windshield was mounted using the top three nuts mounted just like the OEM windshield, which left the top a bit loose. He didn't have the two lower tabs bolted down. This gave the windshield three adjustments for angle or height of the screen. Pretty simple mods make a big difference. Fred http://www.arrowheadmotorsports.com http://www.canyonlandsmotorclassic.com

----- Original Message ----- From: "patod02703" To: DSN_klr650@yahoogroups.com> Sent: Thursday, August 08, 2002 7:28 AM Subject: [DSN_klr650] Kawi tall windshield > Put my new to me Kawi +4 windshield on my bike last night. Kawi's > website says something like "uses original mounting hardware". But in > order to get it secure using the original 5 bolts only, I had to turn > the plastic "nuts" (which the top 3 bolts go into) the wrong way > around. Is this okay, or should I just get some rubber washers from > Home Depot, or am I doing something really dumb?? > >

Posted: **Thu Aug 08, 2002 9:15 am**

Hello. this is my first time posting on this board. I bought my very first bike in April of this year. It is a 1999 KLR650. I haven't hadn't had any problems with it until just recently. There was a piece of plastic of some sort caught in the carburetor which caused the carb to flood cause the needle would not close properly. I took that out. Now the engine doesn't flood but whenever I try to open the throttle, it dies on me. I thought it was the diaphragm, so I checked it out, and it is correctly in place with no punctures. Also checked out the air/gas mixture, and it is set to 1 7/8, which was mentioned in the manual. The bike works ok when it's on choke, but when it warms up and I close choke, the bike won't accept any operation of the throttle. Thanks for helping out. Daniel Montreal,Canada

Wilsons Sandbox

kawi tall windshield

kawi tall windshield

carburetor trouble