Page 1 of 1
home made
Posted: Sat Jan 13, 2001 7:48 pm
by Razvan
I was ready to install the balancer chain upgrade on my 94 KLR but couldn't wait
to get a magneto holder so i made one myself. Cheap too. Baught a 32mm size wrench cut about 1 inch and welded it in the shape of the real magneto holder.
All for under 20$ including welding electrodes.
[img]cid:part1.3A610671.425382F1@...[/img]
More when I finis installing.
Later
Raz
A8
klr 650 rear break rotor dimensions
Posted: Wed Jan 17, 2001 7:11 pm
by Larry Moore
I need some help checking the dimensions of the rear break rotor on a KLR650. What I need to know is the following:
the distance in mm's between opposing bolt centers,should be around 135mm ,and the usable swept area diameter, should be around 35mm. Any help in confirming these dimensions would be greatly appreciated. I went to the local Kawasaki dealer and they didn't have a KLR650 to measure.
Thanks!
Larry Moore
Tampa, Fla