fore sale 1999 a13 pittsburgh pa

[Ron Crandell]

--- In DSN_klr650@yahoogroups.com, "bzrc" wrote:

> > i used a kit from skootworks to lower the rear. they mentioned the > front could be lowered to keep the machine geometry the same.

sounds

> simple but the forks are not sliding after loosening the clamp > brackets. is there some device or procedure that will make

adjusting

> the fork tubes simpler?

Don't forget to loosen the clamps for the fork protectors, and slide them down the appropriate distance from the top only. I then tighten the clamps again and that is my stop to keep the forks from sliding too far.. Way easy to over-look this step. Ron in MN