spike55_bmw wrote:
>The 10mm socket on a 3/8" drive is small enough to do my '06 sprocket
cover. I think that a 1/4" drive wrench
>is too small for routine use on the KLR, especially when using blue
loctite / permatex on everything.
>I'd also consider sticking with 6-pt sockets so there is less chance of
rounding highly torqued bolt heads.
I normally use a 1/4" drive socket set for most work on all my motorcycles.
I have a tendency to strip or break off bolts otherwise. I use 3/8" or
1/2" drive for the big stuff, but the 1/4" drive gets used almost 90% of
the time.
Paul Streeter
Minnesota
[Non-text portions of this message have been removed]