engine?
-
- Posts: 82
- Joined: Mon Jun 07, 2010 3:50 pm
engine?
Just thought about it a little. The threaded holes the plugs you speak of
allow access to may actually be oil passages that were machined into the
head then plugged. Either way whatever it is for you can still remove them
to reseal it.
Walt
-----Original Message-----
From: DSN_KLR650@yahoogroups.com [mailto:DSN_KLR650@yahoogroups.com] On
Behalf Of k650@...
Sent: Friday, September 03, 2010 17:26
To: 'Brad'; DSN_KLR650@yahoogroups.com
Subject: RE: [DSN_KLR650] Engine?
They are just plugs - probably a tapered pipe thread. The other side is the
area where the cam chain resides.
They don't do anything else except plug the hole. On their centerlines in
the head on the other side of that area are threaded holes. It is just a
guess but they may be there so you can remove the plug and thread a bolt in
there to keep the chain from falling down when you remove the cams?
Anyway make sure they are actually leaking and that the oil is not coming
down from the valve cover gasket. If you are sure they are leaking try
tightening them a tweak. If that doesn't work you can safely remove them
and then I would recommend using Teflon tape.
Walt
-----Original Message-----
From: DSN_KLR650@yahoogroups.com [mailto:DSN_KLR650@yahoogroups.com] On
Behalf Of Brad
Sent: Friday, September 03, 2010 16:32
To: DSN_KLR650@yahoogroups.com
Subject: [DSN_KLR650] Engine?
Just below the valve cover, cam chain side, there's 2 round looking plugs
with a hex fitting. What are these. Can't find anything in my manual. The
front one is sweating a little oil. Busy doing carb mod, Thermo Bob,
doohicky and Happy Trails panniers, crash bar and skid plate. So far all is
going well.
Brad
09 KLR
Who is online
Users browsing this forum: No registered users and 19 guests