Hey
Helmet holder: The part Number was right, #98868, and while supplies last in some stores. has a Hand hole no screw holes so I use a screw in hook on the wall and a nail in the floor joist in the basment for winter storage.
Rod holder?: ($6.-$8.) I'm making one out of 2-2.5 in. PVC. using an adaptor (reducer) to 1.5inchs so it fits nice on my left REAR foot peg, (may use heat gun to square alittle) to hold the bottom.
I will then file a flat spot or grove so a strap does not let it slide non bumps, then I will strap it to the back luggage rack to hold the top end up.
Then CLOSE to the top drill small hole so i can ZIP-STRIP a velcro strap to snug the pole inside from bouncing inside.
(Carry the reel seperate.)
Lightly sand, paint to match bike. ($3. more if you don't have extra paint sitting around.)
Note: IT WILL press against the rear plastic alittle.
Had to wait today so I make sure My flyrod case will also fit, (long snug canvas covered tube, and ROD & Reel holder.
will ride like a Rifle, in a sheith on a horse.
Mark (W. Mi.)