Re: Arc defined by two points and a radius [1 Attachment]

Cadintoshmac
Post Reply
bon.ohsato
Posts: 2
Joined: Sat Dec 01, 2012 3:31 am

Arc defined by two points and a radius

Post by bon.ohsato » Wed Nov 19, 2014 5:06 am

Attachments :
  1. [url=file:///C:\Users\thorstenlemke\AppData\Local\PG Offline 4\Attachments\cadintoshmac\Arc.PDF]Arc.PDF[/url]
If I use a.m. command, dimension of the created arc is not correct.


For example;

 - Draw two parallel lines spacing, 10mm

 - Define two points at the end of lines
 - Then "select point for side  of center point" and input radius, 5mm



As shown on the attached PDF, dimension of the arc is changed according to the position I have pointed.
Green circles on the PDF show where I have pointed.
I cannot achieve correct dimension, 5.0, wherever I point.

However the radius of the created arcs are correct, R5 in this case.

This phenomenon was observed in version 7.xx too.


My system:

MacBook Pro retina, OSX Yosemite
Cadintosh 8.1 (build 200)

thorstenlemke
Posts: 127
Joined: Sun Oct 13, 2013 7:45 pm

Re: Arc defined by two points and a radius [1 Attachment]

Post by thorstenlemke » Sat Nov 22, 2014 6:35 pm

Dear Bob,
many thanks for your report.
We can not reproduce the issue here.So, please e-mail your drawing zipped. The pdf is a bit useless for testing.
Thorsten

If I use a.m. command, dimension of the created arc is not correct.
For example;
 - Draw two parallel lines spacing, 10mm
 - Define two points at the end of lines - Then "select point for side  of center point" and input radius, 5mm

As shown on the attached PDF, dimension of the arc is changed according to the position I have pointed.Green circles on the PDF show where I have pointed.I cannot achieve correct dimension, 5.0, wherever I point. 
However the radius of the created arcs are correct, R5 in this case.
This phenomenon was observed in version 7.xx too.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests