Page 1 of 1
dimensioning with parallel line tool
Posted: Wed Oct 26, 2016 6:25 pm
by gsettera@comcast.net
I am testing 8.2.1 build 284. after creating the tutorial plans, I attempted to add dimensions to the rooms. The dimension arrows sometime snap to the outer line (the reference line for the parallel tool) and sometimes snap to the drawn line. This results in the dimensions being off by the width of the "wall". Is there some setting that can alleviate this problem? I am using osx 1.9.5. Thanks.
Re: dimensioning with parallel line tool
Posted: Wed Oct 26, 2016 8:48 pm
by thorstenlemke
Hello,
please e-mail your drawing to
support@lemkesoft.de (as a zipped version).
Thorsten
I am testing 8.2.1 build 284. after creating the tutorial plans, I attempted to add dimensions to the rooms. The dimension arrows sometime snap to the outer line (the reference line for the parallel tool) and sometimes snap to the drawn line. This results in the dimensions being off by the width of the "wall". Is there some setting that can alleviate this problem? I am using osx 1.9.5. Thanks.
Re: dimensioning with parallel line tool
Posted: Thu Oct 27, 2016 1:14 am
by gsettera@comcast.net
Hello,
I figured it out. I didn't notice that the Freehand selection tool was a snap to grid tool. All is good now.
Gsettera